SWAN Concentrator and WAN Subsystem Troubleshooting Guide

Error and Informational Messages With Recovery
Actions
SWAN Concentrator and WAN Subsystem Troubleshooting Guide—426992-008
7-2
BOOTP Error Messages
BOOTP Error Messages
The messages in this section are generated by the WANBoot process which
implements BOOTP.
1502
The firmware file name is not configured.
Message
Recovery
Check whether the KERNELCODE attribute of the ADAPTER is configured. You may
need to configure the KERNELCODE attribute if it has not been configured. Other than
the EMS message, there is no other effect for this message.
1502
The CLIP VPROC mismatches the firmware configured.
Message
Recovery
The firmware file configured in the KERNELCODE attribute does not match the
VPROC obtained from the CLIP. FIRMUP the CLIP with the firmware configured in the
KERNELCODE attribute.
WANBoot:
BOOTP received for SWAN00 TRACKID X017R3,
CLIP 1, IP Address 192.168.10.190, Path A
VPROC: T7954G01^15APR99^30MAR99AAE
Firmware filename not configured
WANBoot:
BOOTP received for SWAN00 TRACKID X017R3,
CLIP 1, IP Address 192.168.10.190, Path A
VPROC: T7954G01^15APR99^30MAR99AAE
WARNING: Firmware version mismatch. Firmup to resolve.