SWAN Concentrator and WAN Subsystem Troubleshooting Guide

Error and Informational Messages With Recovery
Actions
SWAN Concentrator and WAN Subsystem Troubleshooting Guide—426992-008
7-4
BOOTP Error Messages
Recovery
Wait for the Dump Received message. Contact your HP service provider with the
CLIP dump file you received and saved at $SYSTEM.ZWANDUMP subvolume.
Versions: Applicable to the T7953AAH SPR and the G06.07 RVU only.
1502
There is a configuration problem found in the CLIP.
Message
Recovery
A configuration problem has been detected in the CLIP. The CLIP continues to issue
BOOTP requests until the problem has been resolved. Check the GatewayIP address,
Subnetmask, and the PATH IP address configured for the CLIP.
Versions: Applicable with T7953AAH and G06.07 only.
1502
The CLIP is sending continuous BOOTP requests.
Message
Recovery
Check to see if the BOOTP requests are still being generated and the BOOTP count is
increasing (you may want to wait a few minutes). If the BOOTP requests are still
continuing, you need to:
1. Check the IP address and the configuration to see if they are correct. This would
be the most probable cause of the repeated requests.
WANBoot:
BOOTP received for SWAN00 TRACKID X017R3,
CLIP 1, IP Address 192.168.10.190, Path A
VPROC: T7954G01^21OCT1999^AAF^R002
Config Problem Detected.
WANBoot:
BOOTP received for SWAN00 TRACKID X017R3,
CLIP 1, IP Address 192.168.10.190, Path A
VPROC: T7954G01^21OCT1999^AAF^R002
BOOTP Count: 22