SWAN Concentrator and WAN Subsystem Troubleshooting Guide

Error and Informational Messages With Recovery
Actions
SWAN Concentrator and WAN Subsystem Troubleshooting Guide—426992-008
7-10
ConMgr Error Messages
ConMgr Error Messages
The messages in this section are displayed by the ConMgr process. The messages
indicate the error messages and indications in Activate PATH and TASK Related
Actions.
Activate PATH: This is a request to ConMgr from a DEVICE to start a LINE which
corresponds to DLC0 or DLC1 tasks in the CLIP (Line 0 or Line 1).
Add task: This is a request to ConMgr from WANMgr to start a DIAG task in the CLIP.
DIAG tasks are usually started for FIRMUP and for other diagnostic purposes initiated
from OSM, TSM, or the SWAN Tools. (The EMS message only appears for G06.07
and later RVUs.)
Status Task: This is a request to ConMgr from WANMgr to check the status of the
tasks in the CLIP. This request is usually initiated by using an SCF STATUS TASK
command or issued by OSM or TSM for diagnostic purposes. (The EMS message only
appears for G06.07 and later RVUs.)
Format (Example 1)
(0)
The action is Activate PATH or Task Related commands (Add/Status/Abort).
(1)
The status is “Successful” or “FAILED”.
(2)
indicates a PATH error. The action was attempted on this PATH and this error was
returned. An explanation of the various errors and the recovery is described later in
this section.
(3)
This is the recovery action to the requesting component (either the DEVICE or
WANMgr). The actions can be as follows:
ConMgr:
Activate PATH for $BSC, LDEV 139 -> (0)
Status : FAILED -> (1)
Path A : Ownership -> (2)
Path B : No Response from CLIP -> (2)
Recovery : Retry after CPU switch -> (3)
Path A DOWN From 1999-10-18 21:49:04 -> (4)
Path B DOWN. Not UP since last BOOTP -> (4)