SWAN Concentrator and WAN Subsystem Troubleshooting Guide

Error and Informational Messages With Recovery
Actions
SWAN Concentrator and WAN Subsystem Troubleshooting Guide—426992-008
7-12
Format (Example 2)
Format (Example 2)
This format indicates that the error message was not a PATH related message, but
was related to the configuration or other possible fatal errors.
(0)
indicates the component that failed.
(1)
indicates the reason for the failure.
Format (Example 3)
This format indicates that even though the Action was successful a warning was
observed. The warning is displayed.
Error Messages
The recovery specified in the error messages correspond to the DEVICE or WANMgr
which requested the specific action. If the recovery is noted as “None”, then you need
to check the reason of the failure, fix the problem and retry again.
501
No response from CLIP.
ConMgr:
Activate PATH for $BSC, LDEV 139, Path A
Status : FAILED
Component: Configuration -> (0)
Reason : TASK Stopped -> (1)
Recovery : None
ConMgr:
Activate PATH for $BSC, LDEV 139, Path A
Status : Successful
Warning : Failed on Path B
Path B : No Response from CLIP
Path B DOWN From 1999-10-18 21:43:00