SWAN Concentrator and WAN Subsystem Troubleshooting Guide

Error and Informational Messages With Recovery
Actions
SWAN Concentrator and WAN Subsystem Troubleshooting Guide—426992-008
7-20
Error Messages
501
No trap response from CLIP.
Message
Recovery
•
The initial request for starting the LINE/DIAG task has been acknowledged by the
CLIP, but the subsequent confirmation has not been sent by the CLIP.
•
If the T7953AAG version of the SWAN firmware is being used, then the TFTP
server process on the host is either not configured/stopped or is giving an error.
Restart the TFTP server process to correct the problem. If the problem persists,
contact your HP service provider.
•
The CLIP has stopped responding due to software problems or PATH errors. You
may need to wait for a period of time to see whether the problem goes away or
correct the physical PATH errors detected. If the problem persists, contact your HP
service provider.
501
TFTP file not found.
Message
Recovery
The TFTP server in the host has returned an error that the program file to be
downloaded is not found. Check that the program file exists. (This error is unusual
since the file check is done by the ConMgr process before requesting a start LINE). If
the problem persists, contact your HP service provider.
ConMgr:
Activate PATH for $BSC, LDEV 139
Status : FAILED
Path A : No Trap Resp from CLIP
Path B : Ownership
Recovery : Retry after CPU switch
ConMgr:
Activate PATH for $BSC, LDEV 139
Status : FAILED
Path A : TFTP File Not Found
Error: 1
Path B : Ownership
Recovery : Retry after CPU switch