SWAN Concentrator and WAN Subsystem Troubleshooting Guide

Verifying the WAN Subsystem

SWAN Concentrator and WAN Subsystem Troubleshooting Guide—426992-008

3-8

Determining the E4SAs, FESAs, GESAs, or G4SAs

to Which a SWAN Concentrator is Connected

Determining the E4SAs, FESAs, GESAs, or G4SAs to Which a

SWAN Concentrator is Connected

Determine the E4SAs, FESAs, GESAs, or G4SAs to which the SWAN concentrator is

connected by using the SCF INFO LIF command for each LIF associated with the

TCP/IP processes that support the SWAN concentrator:

INFO LIF $ZZLAN.lif-name

Determining the LIFs and PIFs for an Adapter on page A-10 shows the output of this

command.

Determining the WANMgr Processes

The primary WANMgr process is always configured in processor 0 and the backup

WANMgr process is always configured in processor 1.

Determining the ConMgr, SNMP Trap Multiplexer, TFTP Server,

WANBoot, and SNMP Agent Processes That Support a SWAN

Concentrator

Determine the names of the ConMgr processes, SNMP trap multiplexer processes,

TFTP server processes, WANBoot processes, and SNMP agent processes that

support the SWAN concentrators by using the SCF INFO PROCESS command:

INFO PROCESS $ZZWAN.#*

Scan the output for the TCP/IP processes that support your SWAN concentrator. The

SNMP trap multiplexer, TFTP server, and WANBoot processes associated with these

TCP/IP processes are the processes that support that SWAN concentrator.

Displaying Information for a WAN Subsystem Process on page A-14 shows the output

of this command.

Determining the Names of the SWAN Concentrators Configured

on a System

Determine the names of the SWAN concentrators configured on a system by using the

SCF NAMES ADAPTER command:

NAMES ADAPTER $ZZWAN.#*

Note. If you do not know the names of the TCP/IP processes that support the SWAN

concentrator, use the SCF INFO ADAPTER command. If you do not know the names of the

LIFs associated with the TCP/IP processes that support the SWAN concentrator, use the SCF

INFO SUBNET command.

Note. If you do not know the names of the TCP/IP processes that support the SWAN

concentrator, use the SCF INFO ADAPTER command.