SWAN Concentrator and WAN Subsystem Troubleshooting Guide

Verifying the SWAN Hardware
SWAN Concentrator and WAN Subsystem Troubleshooting Guide—426992-008
4-13
Correcting SWAN Concentrator Cabling
Correcting SWAN Concentrator Cabling
•
If the Ethernet cables are reversed, switch the cables so that they are connected to
the correct ports on the SWAN concentrator.
•
If an Ethernet cable is connected to the wrong E4SA, FESA, GESA, or G4SA port,
connect the cable to the configured E4SA, FESA, GESA, or G4SA port or
reconfigure the SWAN concentrator to use the E4SA, FESA, GESA, or G4SA port
to which it is connected.
•
If both cables are connected to the same Ethernet segment, connect one of the
cables to a different Ethernet segment. You must also reconfigure the SWAN
concentrator to use a TCP/IP process and IP address on the new Ethernet
segment and reconfigure the IP addresses for the corresponding SWAN
concentrator path.
•
If a cable is not operational, replace it with a good cable.
Verifying the SWAN Concentrator Track-ID
The nonshaded area of Figure 4-1 shows the location of the configuration track-ID on
the rear panel of a SWAN concentrator. Figure 4-2 on page 4-14 shows the location of
the configuration track-ID on the rear panel of a SWAN 2 concentrator.
To display the configuration track-ID configured for your SWAN concentrator, use the
SCF INFO ADAPTER command:
conc_name
is the name of the SWAN concentrator (ADAPTER object).
Figure 4-1. SWAN Concentrator Label, Configuration Track-ID
INFO ADAPTER $ZZWAN.#conc_name, TRACKID
VST868.vsd
HI-POT
PATH
A B A B A B
CLIP
123
PWA:106523XXX-XX
LA: 08008EXXXXXX
LA: 08008EXXXXXX LA: 08008EXXXXXX LA: 08008EXXXXXX LA: 08008EXXXXXX LA: 08008EXXXXXX
Configuration Track-
ID
TC XXXXXX
100-240VAC,
50/60 HZ, IA
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE
2. THIS DEVICE MUST ACCEPT ANY INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
1. THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE.
FOLLOWING TWO CONDITIONS:
THIS CLASS A DIGITAL APPARATUS MEETS ALL REQUIREMENTS OF THE CANADIAN
DU REGLEMENT SUR LE MATERIEL BROUILLEUR DE CANADA.
CET APPAREIL NUMERIQUE DE LA CLASSE A RESPECTE TOUTES LES EXIGENCES
INTERFERENCE-CAUSING EQUIPMENT REGULATIONS.
MODEL T/3880
ASM: 114645XXX-XX
XXXXXX