SWAN Concentrator and WAN Subsystem Troubleshooting Guide

Verifying the SWAN Hardware
SWAN Concentrator and WAN Subsystem Troubleshooting Guide—426992-008
4-14
Verifying the SWAN Concentrator Track-ID
If the configuration track-ID that is displayed by the SCF INFO ADAPTER command
does not match the configuration track-ID that is printed the rear panel of your SWAN
concentrator, you must alter it.
Altering the Configured Configuration Track-ID
Before you can alter the configuration track-ID, you must first stop the SWAN
concentrator and all of its subordinate objects (SERVER, PATH, and TASK) using the
SCF STOP ADAPTER command:
Use the SCF ALTER ADAPTER command to alter the configuration track-ID:
The configuration track-ID is case sensitive. If you specify the value incorrectly, you will
not be able to use the SWAN concentrator.
Use the SCF START ADAPTER command to restart the SWAN concentrator and all of
its subordinate objects (SERVER, PATH, and TASK) after you have altered the
configuration track-ID:
Figure 4-2. SWAN 2 Concentrator Label
STOP ADAPTER $ZZWAN.#conc_name, SUB ALL
ALTER ADAPTER $ZZWAN.#conc_name, TRACKID "config-track-id"
START ADAPTER $ZZWAN.#conc_name, SUB ALL
MAC Address
Track ID
VST996.vsd