SWAN Concentrator and WAN Subsystem Troubleshooting Guide

Installing and Using the SWAN Tools
SWAN Concentrator and WAN Subsystem Troubleshooting Guide—426992-008
5-3
QUEST Command Syntax
QUEST Command Syntax
The QUEST command has this syntax:
-f dumpfile
specifies the dump file name.
-c ieee.x
converts the main memory portion of the dump ranging from 0x400000 to
0x73FFFF to an IEEE formatted file.
-v
specifies the current version of the utility.
Table 5-1. Dump Information
Format ID Features
FID1 Dump format ID
STACKFRAME
Size of SWAN control table
SWAN control table
Size of raw memory
Size of flash and CLIP PAL memory
Starting address of flash memory
Flash memory contents
Size of DPRAM memory
Starting address of DPRAM memory
DPRAM memory contents
Size of DRAM memory
Starting DRAM memory
DRAM memory contents
FID2 FID1 features plus
MOREINFO
FID3 FID2 features plus
TCBINFO
FID4 FID3 features plus
Software Watchdog Timer (SWT) info
quest [-f]dumpfile [-c [ieeeFilename][-v] [-h]
[-H={0|[n1,n2,n3,...nn}] [-ioptions]
Note. Note that this QUEST command provides all the necessary information from the dump
file and is the most commonly used command:
quest -ia dumpfile