SWAN Concentrator and WAN Subsystem Troubleshooting Guide

Installing and Using the SWAN Tools
SWAN Concentrator and WAN Subsystem Troubleshooting Guide—426992-008
5-12
QUEST2 Interfaces
This is an example for NSK:
TACL> quest2 -ioption $system.zwandumpp.D1023005
An example for UNIX:
$ quest2 -ioption /h/temp/D1023005
User Interactive Interface
From the command line interface, you can enter into the user interactive mode by
typing quest2 at the TACL prompt or $ prompt (UNIX).
For example, this QUEST2 command entered at the NonStop Kernel TACL prompt
would put the user into the interactive interface:
TACL>quest2
This QUEST2 command entered at the UNIX prompt ($) would put the user into the
interactive interface:
$ quest2
Either command returns header information such as:
QUEST - CLIP Dump Analyzer - T0465 - (08OCT2001) 10/30/2001
17:07:13 Copyright Compaq Computer Corporation
In the user interactive mode, the dump file should be opened using this command:
TACL>quest2
-->open dumpfile
Once the dump file is opened, any command or option shown in the online help can be
given at the interactive prompt.