SWAN Concentrator Installation and Support Guide

Installing a SWAN Concentrator
SWAN Concentrator Installation and Support Guide—429391-006
2-10
Step 3: Connecting the Ethernet Cables
If you ordered your SWAN concentrator without a system, you must configure the
adapters and adapter port connections to your SWAN concentrator. Refer to the WAN
Subsystem Configuration and Management Manual for more information.
The following figure shows the Ethernet ports on an E4SA that connect to a SWAN
concentrator. The E4SA has four Ethernet ports labeled ENET 0A, ENET 0B, ENET
1A, and ENET 1B.
SAC 1
ENET 0B
ENET 0A
ENET 1A
ENET 1B
SAC 0
Ejector
Ethernet 4 ServerNet Adapter (E4SA)
RX
TX
COL
LNK
RX
TX
COL
LNK
RX
TX
COL
LNK
RX
TX
COL
LNK
Power-On LED (green)
Fault LED (amber)
Receive Data (green)
Transmit Data (green)
Collision Detect (green)
Link Integrity (green)
RJ-45 Connector
Ethernet
Hub
RJ-45
Connector
To Ethernet Port A or B on
the SWAN Concentrator
VST860.vsd