SWAN Concentrator Installation and Support Guide

Contents

SWAN Concentrator Installation and Support Guide—429391-006

2. Installing a SWAN Concentrator (continued)

Removing a SWAN Concentrator 2-27

Replacing a SWAN Concentrator 2-29

Updating the SWAN Kernel Firmware 2-32

3. Using OSM to Update SWAN CLIP Firmware

Using the Multi-Resources Actions Dialog Box 3-1

Step 1: Stop the SWAN Concentrator and CLIPs 3-2

Step 2: Check the Location and Version of the SWAN Firmware 3-3

Step 3: Initiate the Firmware Update 3-3

Step 4: Start the SWAN Concentrator and CLIPs 3-5

4. Using TSM to Update SWAN CLIP Firmware

Using the SWAN Fast Firmware Update Guided Procedure 4-1

Using the Firmware Update Dialog Box 4-6

Summary of Steps for Updating SWAN CLIP Firmware 4-6

Step 2: Check Location and Version of New SWAN CLIP Firmware 4-8

Step 3: Check Current Firmware Version in the SWAN CLIPs 4-8

Step 4: Stop the SWAN Concentrator and CLIPs 4-8

Step 5: Point SWAN Concentrators to the New Firmware Object Code File 4-10

Step 6: Initiate the Firmware Update Using TSM 4-11

Step 7: Start the SWAN Concentrator and CLIPs 4-13

Step 8: Verify That the SWAN CLIPs Are Running the Latest Firmware 4-13

Step 9: Start Stopped Lines (If Necessary) 4-13

A. Diagnosing and Correcting SWAN Concentrator Problems

Diagnostic (DIAG) Tasks A-1

FIRMUP Procedure

A-1

SWAN CLIP Test Actions

A-2

FIRINIT Task A-3

Test Verify Action Procedure A-3

Power On Self-Test (POST) A-4

Troubleshooting Firmware Problems A-4

What to Do if OSM Fails to Update a CLIP A-4

What to Do if the SWAN Fast Firmware Update Fails (TSM) A-6