SWAN Concentrator Installation and Support Guide

Installing a SWAN Concentrator
SWAN Concentrator Installation and Support Guide—429391-006
2-18
Step 4: Connecting the Interface Converter Cables
to the WAN Ports
Figure 2-8 shows the interface-specific connectors on the other end of the interface
converter cables.
To attach an interface converter cable, connect the interface-specific connector to the
connector on the your cable. Then connect the 50-pin connector to the appropriate port
on the SWAN concentrator and secure it by tightening the lock-down screws with a
flat-head screwdriver (finger tight is usually sufficient).
Figure 2-8. Interface-Specific Connectors on the Interface Converter Cables
RS-232 DB-25
Top View
Side View
RS-449 DB-37
Side View
V.35 34-Pin Connector
Side View
X.21 DB-15
Side View
Top View
Top View Top View
VST835.vsd