SWAN Concentrator Installation and Support Guide

Installing a SWAN Concentrator
SWAN Concentrator Installation and Support Guide—429391-006
2-28
Removing a SWAN Concentrator
9. If the SWAN concentrator is installed in a 19-inch rack, follow Step 9a and Step 9b
(following) to remove it from the rack. See Figure 2-14.
a. One person should support the SWAN concentrator while the second person
loosens and removes the screws from each mounting bracket.
b. Lift the SWAN concentrator from the rack and lay it on a flat surface.
Note. Removing a SWAN concentrator from a rack requires two people. The SWAN
concentrator weighs approximately 12 pounds (approximately 5.5 kilograms).
Figure 2-14. Removing a SWAN Concentrator From a 19-Inch Rack
POWER
CLIP 1 CLIP 2 CLIP 3
FAULT FAULT
FAULT
10BASE-T
PATH
LNK
TX
COL
RX
LNK
TX
COL
RX
A B
VST873.vsd