SWAN Concentrator Installation and Support Guide

Using TSM to Update SWAN CLIP Firmware

SWAN Concentrator Installation and Support Guide—429391-006

4-5

Using the Firmware Update Dialog Box

Summary of Steps for Updating SWAN CLIP Firmware

1. Step 1: List the Names of the SWAN Concentrators and CLIPs.

2. Step 2: Check Location and Version of New SWAN CLIP Firmware.

3. Step 3: Check Current Firmware Version in the SWAN CLIPs.

4. Step 4: Stop the SWAN Concentrator and CLIPs

5. Step 5: Point SWAN Concentrators to the New Firmware Object Code File

6. Step 6: Initiate the Firmware Update Using TSM

7. Step 7: Start the SWAN Concentrator and CLIPs

8. Step 8: Verify That the SWAN CLIPs Are Running the Latest Firmware

9. Step 9: Start Stopped Lines (If Necessary)

Step 1: List the Names of the SWAN Concentrators and

CLIPs

Use the TSM Service Application or SCF to list the names of the SWAN concentrators

and CLIPs in your system:

Note. This procedure requires that:

•

Your system is running the latest version of the WANBoot process (T7909) and its

requisites (WANMgr [T8365], WAN SCF Product Module [T7925], and ConMgr [T7922])

•

The version of the C7953P00 file is T7953AAG, or later. If not, special steps are required.

See the current list of Hotstuffs and Support Notes for additional SWAN firmware

information.