System Generation Manual for G-Series RVUs

SYSGENR Messages
System Generation Manual for G-Series RVUs—523407-001
A-24
SYSGENR Message Descriptions
Cause. Too many ASSIGN commands are entered for file-name assignments. The
number of such ASSIGN commands is limited to 200. This message appears in the
body of the listing, at the point where the error was detected.
Effect. SYSGENR terminates.
Recovery. Delete any unnecessary ASSIGN commands, and rerun SYSGENR.
Cause. When trying to create a process, SYSGENR has found too many processes in
the entrypoint table.
Effect. SYSGENR terminates.
Recovery. Gather the items listed on page A-1, then call your service provider.
Cause. The process being built is not native microcode, but it requires two VSEGs.
This is an internal problem in the process code file being listed.
Effect. SYSGENR terminates.
Recovery. Gather the items listed on page A-1, then call your service provider.
Cause. An ASSIGN command has been entered by an operator or by DSM/SCM, but
SYSGENR cannot start the assigned process due to NEWPROCESS error %nnn.
This message appears in the body of the listing, at the point where the error was
detected.
MORE THAN 200 ASSIGNS
NAMED SYSTEM PROCESS TABLE OVERFLOW
NATIVE UC CAN HAVE TWO VSEGS (512 SEGMENTS), OTHERS: MAX 1
VSEG
NEWPROCESS ERROR %nnn TRYING TO CREATE { BACKUP } PROCESS
{ BINDER }
{ DISKGEN }
{ SWID }
ASSIGN Command SYSGENR Uses Instead
SYSGEN^BACKUP The version of BACKUP at the SYSGENR
default volume and subvolume