System Generation Manual for G-Series RVUs

SYSGENR Messages
System Generation Manual for G-Series RVUs—523407-001
A-27
SYSGENR Message Descriptions
Recovery. If you want to reuse a SYSCLR file, then specify the ASSIGN for this.
Otherwise, omit the PARAM REUSESYSFILES command.
Cause. You have specified a PARAM REUSESYSFILES 1, 3, YES, or TNS command,
but omitted a corequisite ASSIGN SYSCOD00 command.
Effect. SYSGENR terminates.
Recovery. If you want to reuse a SYSCOD00 file, then specify the ASSIGN for this.
Otherwise, omit the PARAM REUSESYSFILES command.
Cause. You have specified a PARAM REUSESYSFILES 1, 3, YES, or TNS command,
but omitted a corequisite ASSIGN SYSLIB00 command.
Effect. SYSGENR terminates.
Recovery. If you want to reuse a SYSLIB00 file, then specify the ASSIGN for this.
Otherwise, omit the PARAM REUSESYSFILES command.
Cause. You have attempted to reuse EMS templates, but did not enter all the
necessary commands.
Effect. SYSGENR finishes scanning the CONFTEXT file and then terminates.
Recovery. Along with the PARAM REUSETEMPLATES command, enter ASSIGN
SYSGENK and ASSIGN SYSGENL commands to specify the location of the resident
and nonresident template files to be reused. Then rerun SYSGENR.
Cause. You have entered a PARAM SYSGEN^BACKUPPARAM command, which
overrode the PARAM TAPE or PARAM DENSITY command you also entered.
Effect. SYSGENR continues, using the BACKUP values specified in the PARAM
SYSGEN^BACKUPPARAM command.
Recovery. If necessary, enter a PARAM SYSGEN^BACKUPPARAM CLEAR
command and rerun SYSGENR.
PARAM REUSESYSFILES USED WITH NO SYSCOD00 ASSIGN
PARAM REUSESYSFILES USED WITH NO SYSLIB00 ASSIGN
PARAM REUSETEMPLATES WILL BE IGNORED. BOTH SYSGENK AND
SYSGENL MUST ALSO BE ASSIGNED.
PARAMS TAPEMODE AND DENSITY ARE IGNORED WHEN
SYSGEN^BACKUPPARAM IS GIVEN