System Generation Manual for G-Series RVUs

SYSGENR Messages
System Generation Manual for G-Series RVUs—523407-001
A-33
SYSGENR Message Descriptions
Cause. One or more errors have occurred during SYSGENR processing. This
message appears at the end of the listing to report the number of errors detected.
Effect. SYSGENR terminates normally, having completed successfully. If nnn
exceeds 100, SYSGENR stops scanning the CONFTEXT file.
Recovery. Correct the errors in the listing and rerun SYSGENR.
Cause. The SYSGENR run is successful. This message appears at the end of the
listing to indicate its successful termination.
Effect. SYSGENR terminates normally, having completed successfully.
Recovery. Informational message only; no corrective action is needed.
Cause. You have entered a PARAM STRESS ONLY command before running
SYSGENR. This message appears at the end of the listing to indicate its termination
status.
Effect. SYSGENR closes the completed CONFLIST file and terminates.
Recovery. Delete the PARAM STRESS ONLY command and rerun SYSGENR.
Cause. An internal SYSGENR error has occurred. This message appears in the body
of the listing, at the point where the error was detected.
Effect. SYSGENR terminates.
Recovery. Gather the items listed on page A-1, then call your service provider.
Cause. The file specified as system code has not been accelerated at the proper
KSEG0 address.
Effect. SYSGENR terminates.
Recovery. Gather the items listed on page A-1, then call your service provider.
SYSGENR COMPLETED -- nnn ERRORS DETECTED ***
SYSGEN COMPLETED -- NO ERRORS DETECTED ***
SYSGEN COMPLETED -- NO SYSTEM IMAGE BUILT ***
SYSGEN STACK OVERFLOW
SYSTEM CODE MUST BE ACCELERATED FOR KSEG0