System Generation Manual for G-Series RVUs

SYSGENR Messages
System Generation Manual for G-Series RVUs—523407-001
A-37
SYSGENR Message Descriptions
Cause. A procedure that is called from the system process library or process code file
filename cannot be found. Either the procedure should not have been called, or it
should have been found.
Effect. SYSGENR lists all the library or code files that called the missing procedure.
Then SYSGENR continues.
Recovery. Gather the items listed on page A-1, then call your service provider.
Cause. You have correctly specified PARAM REUSESYSFILES and ASSIGN
SYSCLR commands.
Effect. SYSGENR continues.
Recovery. Informational message only; no corrective action is needed.
Cause. You have correctly specified a PARAM REUSETEMPLATES or ASSIGN
SYSGEN^TEMPLI command before running SYSGENR.
Effect. SYSGENR continues.
Recovery. Informational message only; no corrective action is needed.
Cause. The system library file filename has no procedures in it. All library files
must contain procedures.
Effect. SYSGENR terminates.
Recovery. Correct the file as needed, and rerun SYSGENR.
Cause. You have configured too large a system.
Effect. SYSGENR finishes scanning the CONFTEXT file and then terminates.
Recovery. Correct the CONFTEXT file and rerun SYSGENR.
THE PROCEDURE IS CALLED FROM filename
THE SYSCLR FILE SUPPLIED BY PARAM AND ASSIGN IS BEING REUSED
THE TEMPLATE FILES SUPPLIED BY PARAM AND ASSIGNS ARE BEING
REUSED
THERE ARE NO PROCEDURES IN LIBRARY FILE filename
THIS CONFIGURATION IS TOO LARGE.