System Generation Manual for G-Series RVUs

SYSGENR Messages
System Generation Manual for G-Series RVUs—523407-001
A-39
SYSGENR Message Descriptions
Cause. You have configured more than 511 library procedures for the system. This
message appears in the body of the listing, at the point where the error was detected.
Effect. SYSGENR terminates.
Recovery. Reduce the number of library procedures and rerun SYSGENR.
Cause. SYSGENR has identified more than 100 errors. This message appears at the
end of the listing to indicate its termination status.
Effect. SYSGENR terminates.
Recovery. Correct the errors in the listing and rerun SYSGENR.
Cause. SYSGENR has found more than three interface modules (IFMs) for XIO.
Effect. SYSGENR finishes scanning the CONFTEXT file and then terminates.
Recovery. Gather the items listed on page A-1, then call your service provider.
Cause. The listed process code file contains too many procedures for SYSGENR to
handle. This message appears in the body of the listing, at the point where the error
was detected. This is an internal problem.
Effect. SYSGENR terminates.
Recovery. Gather the items listed on page A-1, then call your service provider.
Cause. The BIND program has terminated for reasons unknown; a BIND message
appears earlier in the listing or was displayed on the home terminal. This message
appears in the body of the listing, at the point where the error was detected.
Effect. SYSGENR terminates.
Recovery. Gather the items listed on page A-1, then call your service provider.
TOO MANY ENTRY POINTS DEFINED
TOO MANY ERRORS!
TOO MANY IFMS CONFIGURED
TOO MANY PROCEDURES IN PROCESS CODE FILE
UNEXPECTED TERMINATION BY BINDER PROCESS