System Generation Manual for G-Series RVUs

SYSGENR Messages
System Generation Manual for G-Series RVUs—523407-001
A-41
SYSGENR Message Descriptions
3. Change the home terminal in the Pathway configuration file:
EDIT PATHHOST
C/old-hometerm/new-hometerm/A
GET INITSTAT
C/old-hometerm/new-hometerm/A
EXIT
4. Incorporate the new values:
RUN PATHCOLD
5. Restart SCM:
RUN STARTSCM
6. Using the DSM/SCM Planner Interface, create a new configuration and start a
build/apply. You can safely ignore the warning message about the previous
build/apply, which completed with errors.
If this error is not caused by an inaccessible home terminal, gather the items listed on
page A-1 and call your service provider.
Cause. The assigned BIND program is incompatible with this version of SYSGENR. If
you did not enter an ASSIGN SYSGEN^BINDER command, then SYSGENR used the
version in $SYSTEM.SYSTEM.BIND. This message appears on the home terminal.
Effect. SYSGENR terminates.
Recovery. Use an ASSIGN SYSGEN^BINDER command to point to a compatible
version of BIND. Then rerun SYSGENR.
Cause. You have entered an ASSIGN SYSGEN^TAPE command to specify the tape
drive for the system image tape (SIT). This message is displayed on the home
terminal and printed in the CONFLIST.
Effect. SYSGENR writes the SIT on the specified drive.
Recovery. Informational message only; no corrective action is needed.
Cause. You have specified a value that is either greater than upperlimit or less
than lowerlimit. This message appears in the body of the listing, at the point where
the error was detected.
Effect. SYSGENR finishes scanning the CONFTEXT file and then terminates.
USING BINDER WITH VERSION B00 OR LATER
USING tape-drive TO WRITE SYSTEM IMAGE TAPE
VALUE OUT OF RANGE: lowerlimit TO upperlimit