System Generation Manual for G-Series RVUs

XLLINK Messages
System Generation Manual for G-Series RVUs—523407-001
B-8
XLLINK Message Descriptions
25
Cause. The file filename contains no BIND region. You must not run XLLINK
outside of SYSGENR.
Effect. XLLINK terminates.
Recovery. If you receive this message when running DSM/SCM or SYSGENR, make
sure that you have not deleted the BIND region from file filename, and, after
gathering the items listed on page B-1, call your service provider.
26
Cause. You have specified the input file filename, which was built by a nonstandard
version of the Binder program. You must not run XLLINK outside of SYSGENR.
Effect. XLLINK terminates.
Recovery. If you receive this message when running DSM/SCM or SYSGENR, gather
the items listed on page B-1, then call your service provider.
27
Cause. You have specified the component file filename, which was not accelerated
with either the linkable option, the SC option, or the SL option.
Effect. XLLINK terminates.
Recovery. If filename is one of your own, make sure that you accelerate each
component module with the linkable, SC, or SL option. If the file is an object file
supplied by HP, gather the items listed on page B-1, then call your service provider.
29
Cause. You have started the XLLINK program, but did not include an output file name
in your command. XLLINK does not know where to write the output file. You must not
run XLLINK outside of SYSGENR.
Effect. XLLINK terminates.
File filename has no BIND region.
XLLINK cannot link the file filename.
File filename was accelerated with the NotLinkable option.
No output file name was provided: