System Generation Manual for G-Series RVUs

Comparing SYSGENR for D-Series RVUs With
SYSGENR for G-Series RVUs
System Generation Manual for G-Series RVUs—523407-001
D-3
Changes to the ALLPROCESSORS Paragraph
for G-series RVUs, along with their replacements. Many of the obsolete entries are
configured automatically or can be specified using an SCF command.
Table D-1. Obsolete ALLPROCESSORS Paragraph Entries (page 1 of 2)
D-Series Entry Replacement on G-Series Reference
BREAKPOINT_CONTROL_
BLOCKS
Automatically set to 50 (the
maximum for each
processor).
--
BUILD_Z0_PROCESS $Z0 process automatically
built during system
generation.
--
CLUSTER_NUMBER FOX is not supported at this
time.
--
DAYLIGHT_SAVINGS_TIME Initially set to NONE. Use
SCF ALTER SUBSYS
command to change.
SCF Reference
Manual for the Kernel
Subsystem
DP2_UPSOPTION Initially set to OFF. Use SCF
ALTER SUBSYS command
to change.
SCF Reference
Manual for the
Storage Subsystem
MAXIMUM_SYSTEMS Automatically set to 255 (the
maximum).
--
NCP_MODIFIERS Configured by the Expand
Network Control Process,
using SCF.
--
NCP_PROCESSORS Configured by the Expand
Network Control Process,
using SCF.
--
OPERATOR_PROCESSORS Automatically set to
processors 0 and 1.
--
PROCESS_CONTROL_BLOCKS Automatically set to 2200
(the maximum for each
processor).
--
REMOTE_DEFAULT_
NEWPROCESS_PROCESSORS
Configured by the Expand
Network Control Process,
using SCF.
--
SYSTEM_NAME Initially set to \NONAME.
Use SCF ALTER SUBSYS
command to change.
SCF Reference
Manual for the Kernel
Subsystem
SYSTEM_NUMBER Initially set to 254. Use SCF
ALTER SUBSYS command
to change.
SCF Reference
Manual for the Kernel
Subsystem