System Generation Manual for G-Series RVUs

Contents of the CONFTEXT File
System Generation Manual for G-Series RVUs—523407-001
2-6
FORMATTER_TEMPLATE_FILES (Required)
The following example is a partial list of the files in a
FILES_TO_COPY_TO_NEW_SYSTEM entry. They are listed in the order in which
DSM/SCM places them in the TANDEM^FILES^TO^COPY portion of the CONFAUX
file.
FORMATTER_TEMPLATE_FILES (Required)
This entry specifies the Event Management Service (EMS) template object files you
wish SYSGENR to use. If you use the CONFAUX file (the normal procedure), you
need enter only the installation descriptor TANDEM^FORMATTER^TEMPLATE^FILES.
The form of this entry is shown here.
If you do not use the CONFAUX file, you must list the
FORMATTER_TEMPLATE_FILES entry, followed by the name of each EMS template
object file required for your system. For multiple template object files, enter a comma
(,) after each file name and a semicolon (;) after the last file name listed.
The following example is a partial list of the EMS template object files in a
FORMATTER_TEMPLATE_FILES entry. They are listed in the order in which
DSM/SCM places them in the TANDEM^FORMATTER^TEMPLATE^FILES portion of
the CONFAUX file.
INITIAL_COMMAND_FILE or INITIAL_COMINT_INFILE (Required)
Whenever you perform a system load, the startup TACL (INIT TACL) process reads
and executes commands listed in the command interpreter IN file (also known as the
FILES_TO_COPY_TO_NEW_SYSTEM $S11B.CONFIG.RLSEID,
$S11B.ZSNMPMGR.SNMPTMUX,
$S11B.ZCEV.CEVETF,
$S11B.ZCEV.CEVEVX,
$S11B.ZCEV.CEVINX,
…
$S11B.ZSECURE.USERID RENAME_TO SYSTEM.USERID,
$S11B.ZSECURE.USERIDAK RENAME_TO SYSTEM.USERIDAK,
…
$S11B.ZCNFDEFS.CONFBASE,
$S11B.ZCS3CAM.C8683P01,
$S11B.ZCNFDEFS.ZPM;
FORMATTER_TEMPLATE_FILES TANDEM^FORMATTER^TEMPLATE^FILES;
FORMATTER_TEMPLATE_FILES $S11B.ZTEMPL.ZLDSTMPL,
$S11B.ZTEMPL.ZTMXTMPL,
$S11B.ZCEV.ZCEVTMPL,
$S11B.ZTEMPL.ZSMDTMPL,
$S11B.ZTEMPL.ZSTOTMPL,
…
$S11B.ZTEMPL.ZRPCTMPL,
$S11B.ZTEMPL.ZNSSTMPL;