System Generation Manual for G-Series RVUs

Using Preprocessing Commands
System Generation Manual for G-Series RVUs—523407-001
3-21
Combining ASSIGNs and PARAMS for the Number
of SIDs and SITs You Want
Combining ASSIGNs and PARAMS for the
Number of SIDs and SITs You Want
Table 3-3 lists the different combinations of system image disks (SIDs) and system
image tapes (SITs) that you can request with the following PARAMs or ASSIGNs:
•
PARAM SYSGEN^DISKGENPARAM
•
PARAM SYSGEN^BACKUPPARAM
•
ASSIGN SYSGEN^TAPE
Table 3-3. SID and SIT Options (page 1 of 3)
No. Quantity PARAM Command SYSGENR Processing Sequence
1. 0, 1, or more
SIDs and
0, 1, or more
SITs
None
(run SYSGENR
without the above
PARAMs)
1. Prompt for DISKGEN (if YES, go to Step
2; if NO, go to Step 5).
2. Prompt for the first SID.
3. Create the first SID.
4. Prompt for another SID until you specify
NO.
5. Prompt for BACKUP (if YES, go to Step 6;
if NO, exit).
6. Prompt for the first SIT.
7. Create the first SIT.
8. Prompt for another SIT until you specify
NO.
2. 1 or more
SIDs and
1 or more
SITs
PARAM
SYSGEN^DISKGEN
PARAM"text"
1. Create the first SID.
2. Prompt for another SID until you specify
NO.
3. Prompt for BACKUP (if YES, go to
Step 4); if NO, exit.
4. Prompt for the first SIT.
5. Create the first SIT.
6. Prompt for another SIT until you specify
NO.
3. 1 or more
SIDs and
1 or more
SITs
PARAM
SYSGEN^BACKUPP
ARAM "text"
1. Prompt for DISKGEN (if YES, go to Step
2; if NO, go to Step 5).
2. Prompt for the first SID.
3. Create the first SID.
4. Prompt for another SID until you specify
NO.
5. Create the first SIT.
6. Prompt for another SIT until you specify
NO.