TACL Reference Manual

UTILS:TACL Commands and Functions
HP NonStop TACL Reference Manual—429513-018
8-4
Commands and Programs
PARAM Command Assigns parameter value to a parameter name, or
displays all current parameters and their values
PASSWORD Program
Establishes or changes your password
PAUSE Command
Makes TACL stop prompting for commands and allows
another process to control terminal
PMSEARCH Command
Defines subvolumes to be searched for program and
macro files
PMSG Command
Controls process-identifier displays of processes you
create or delete
POP Command
Removes top level of variable or built-in function
POSTDUMP Utility
Enables explicit postdump processing of an existing
full dump file to produce an extracted dump file.
PPD Command Displays names, cpu,pin designations, and ancestors
of processes currently running
PURGE Command
Purges (deletes) a disk file
PUSH Command
Adds a level to a variable
REMOTEPASSWORD
Command and RPASSWRD
Program
Defines remote password for use in network security
(runs RPASSWRD program)
RENAME Command
Renames a disk file
RESET DEFINE Command
Restores attributes in DEFINE working set to their initial
values
REMOTEPASSWORD
Command and RPASSWRD
Program
Establishes or changes remote password
RUN[D|V] Command
Runs a program; optionally puts resulting process into
debug state
SEGINFO Command
Shows information about TACL segment files
SEMSTAT Program
Prints BINSEM usage information and statistics for a
process whose ID or process name is provided
SET DEFINE Command
Establishes a value for one or more DEFINE attributes in
working attribute set
SET DEFMODE Command
Controls whether DEFINEs are enabled for current
TACL process and are propagated to new processes
SET
_DO_NOT_PROMPT_TACL_ST
OP Command
Specifies whether to display a confirmation message
before stopping one or more running processes
SET HIGHPIN Command
Specifies the default PIN range for processes started by
the TACL process
Table 8-1. Commands and Programs (page 4 of 5)
Command or Function Description