TACL Reference Manual

What’s New in This Manual
HP NonStop TACL Reference Manual—429513-018
xvii
Changes to the 429513-017 manual
•
Added information on SET _DO_NOT_PROMPT_TACL_STOP Command on
page 8-195.
•
Updated the Considerations section of the STATUS Command on 8-211.
•
Updated the Examples section of the STATUS Command on 8-216 and 8-216.
•
Updated the information in Table 7-2, Informational Built-In Functions and
Variables, on page 7-5.
•
Updated the information in Table 9-1, Built-In Functions, on page 9-2.
•
Updated #XSTATUS Built-In Function on page 9-423.
•
Updated the information in the Considerations section of #CHANGEUSER Built-In
Function on page 9-42.
•
Updated the information in Table C-1, TACL Built-In Functions and Guardian
Procedures on page C-6.
•
Added SPR Requirements for Increased Enscribe Limits for the H06.28/J06.17
Release on page 1-1.
Changes to the 429513-017 manual
•
Modified the description of the STOP option on page 8-209.
•
Added the FORCED option and its description on page 8-209.
•
Added a confirmation message below the command line on page 8-216.
•
Added more modes in the table and modified the information on modes under
mode on page 9-361.
•
Modified the information on error results under Result on page 9-361.
•
Added more information on customization of TACLCSTM and TACLLOCL under
Customizing the TACL Environment
.
•
Added the IPUASSOCIATION, IPUNUMBER, PROCESSCREATIONTIME, and
PROGRAMDATAMODEL options under #PROCESSINFO Built-In Function on
pages 9-297
, 9-299, 9-301.
•
Added new information on the output of the TACL STATUS command along with
the DETAIL option under Considerations on page 8-212
.
•
Added a new section Installation Instructions on page 6-1.
•
Added three states of an ancestor and their description under aid on page 8-127.
•
Added a note on subvolume names and #PMSEARCHLIST on page 9-288.
•
Modified STATUS Command on page 8-207.