TACL Reference Manual

UTILS:TACL Commands and Functions
HP NonStop TACL Reference Manual—429513-018
8-125
POSTDUMP Utility
Examples
To process a full dump file CPU01 and create an extracted dump CPU01P, run the
following command:
10> POSTDUMP CPU01
Note. Whether installed by default or explicitly installed, the POSTDUMP utility can be used to
produce an extracted dump from a full dump of any NS-series processor that was running the
H06.13 RVU or later, or from a full dump of any HP Integrity NonStop™ BladeSystems (which
runs a J-series RVU).
The POSTDUMP utility can be run on such a system that was running the H06.13 RVU or later
to process a full dump file from any other NS-series processor or a full dump file from any
NonStop BladeSystems. The POSTDUMP utility does not rely on any of the other files
(RCVDUMP, ONLINDMP, ZDMPDLL).