TACL Reference Manual

UTILS:TACL Commands and Functions
HP NonStop TACL Reference Manual—429513-018
8-135
RCVDUMP Program (Super-Group or Super ID
Only)
operations. By default, both the full dump and extracted dump files are created.
You may use either PARALLEL or ONLINE but not both.
FULL
Specifies that only a full dump is to be created and not an extracted dump.
G-Series Syntax
run-option
is any of the options described in the RUN[D|V] Command on page 8-156.
dump-file
is the name of the disk file to which the dump is to be written.
cpu
is the number of the processor that is to be dumped. Specify cpu as an integer in
the range from 0 through 15.
fabric
specifies the ServerNet fabric to be used for the dump operation. The default fabric
is the X fabric. Possible values are:
X = X fabric
Y = Y fabric
param
is one or more of these parameters:
Note. When neither ONLINE nor PARALLEL is specified:
•
On an NSAA system, a full dump file is always created. An extracted dump
file is created, by default.
•
On a non-NSAA system, a full dump file is not created if the processor to be
dumped is running a version of Halted State Services that supports direct
creation of an extracted dump without a full dump. Otherwise, a full dump file
is created. An extracted dump file is created, by default.
Note. This option is supported only on systems running J06.03 and later J-series RVUs
and H06.14 and later H-series RVUs.
RCVDUMP [ / run-option [ , run-option ] ... / ]
dump-file , cpu , [ fabric, param [ , param ] ]