TACL Reference Manual

UTILS:TACL Commands and Functions
HP NonStop TACL Reference Manual—429513-018
8-145
RELOAD Program (Super-Group Only)
cpu-cpu
is two processor numbers separated by a hyphen, specifying a range of
processors. In a range specification, the first processor number must be
less than the second.
option
is one of these:
NOSWITCH
[PRIME|NOPRIME]
<fabric>
<$volume [.sysnn.osimage]>
NOSWITCH
specifies that, when a processor is reloaded, there is no default autoswitch
of controller ownership to the configured primary processor.
[PRIME|NOPRIME]
Sets up the logical processor for the reload operation.
NOPRIME is the default.
fabric
specifies whether the X fabric or Y fabric is used for the transfer of the
operating system image to the processor during the RELOAD operation.
0 = X fabric
1 = Y fabric
The default option is the X fabric.
<$volume [.sysnn.osimage]>
specifies a volume other than $SYSTEM where the operating system
image (SYSnn.OSIMAGE) to be used for reloading the processor is
located.
This specification could take the form of $volume or
$volume.sysnn.osimage or sysnn.osimage or osimage depending
on your requirements.
If a subvolume is not specified, the default subvolume in effect at the time
the RELOAD command is issued is used.
*
specifies that all failed processors should be reloaded.