TACL Reference Manual

Error Messages
HP NonStop TACL Reference Manual—429513-018
B-51
RCVDUMP Error Messages
If the second number is 3, 5, 8, 11, 13, 14, or 15, the third number contains a file-
system error number identifying the specific error condition.
If the second number is 6, the third number contains either 0, specifying that the
program file is in error, or 1, specifying that the library file is in error. The fourth number
contains a value in the range 1-14 that specifies why the file format is invalid. The
numbers correspond to the positions in the list of process creation “illegal format” error
messages given in the preceding list; for example, 3 indicates the main procedure is
missing.
RCVDUMP Error Messages
The following messages are returned by the RCVDUMP procedure. Use of the
RCVDUMP and RECEIVEDUMP commands is restricted to super-group users only.
RCVDUMP error messages are divided into two subsections:
•
Messages for H-series only. These are all designated by the prefix ‘DUMP_’.
•
Messages common to all systems, H-series, G-series and D-series. The wording
may differ slightly between systems.
RCVDUMP Error Messages for H-Series Only
Cause. You specified a parallel dump without the slice option, but more than one slice
is in a stopped state.
Effect. RCVDUMP does not continue processing.
Recovery. Specify the slice from which the PE is to be dumped.
Cause. You specified both parallel and online options. This is not possible.
Effect. RCVDUMP does not continue processing.
11 File-system error occurred on library file
12 Program file and library file specified are the same file
13 Extended data segment initialization error
14 Extended segment swap file error
15 Illegal home terminal
DUMP _SLICE_NOT_SPECIFIED
DUMP_PARAM_CONFLICT
Table B-1. #ERRORNUMBERS Results (page 2 of 2)
Number Error