TACL Reference Manual

Error Messages
HP NonStop TACL Reference Manual—429513-018
B-58
RELOAD Error Messages
Cause. The specified file could not be purged because file-system error nnnn
occurred
Effect. No processor is dumped.
Recovery. Correct the cause of the file-system error and reenter the command.
Cause. The specified file could not be written to because file-system error nnnn
occurred.
Effect. No processor is dumped.
Recovery. Correct the cause of the file-system error and reenter the command.
Cause. You specified PRIME or NOPRIME and this feature is not supported for the
type of processor.
Effect. No processor is dumped.
Recovery. Reenter the command without PRIME or NOPRIME.
RELOAD Error Messages
The following messages are returned by the RELOAD procedure. Use of the RELOAD
command is restricted to super-group users only.
RELOAD error messages are divided into two subsections:
•
Messages for H-series only
•
Messages common to all systems, H-series, G-series and D-series. The wording
may differ slightly between systems.
RELOAD Error Messages for H-Series Only
RELOAD prints several error messages at different stages. Many of these give
reasons as to why the RELOAD of a particular CPU failed. The RELOAD process will
still continue, since failure for one CPU does not indicate that other CPUs won’t
RELOAD. There are other error messages which indicate general problems (like file
system errors) that are more likely in the initial stages of RELOAD. Such errors would
UNABLE TO PURGE file-name, ERROR nnnn.
UNABLE TO WRITE TO file-name, ERROR nnnn.
** WARNING ** PRIME/NOPRIME IS NOT VALID FOR
THIS PROCESSOR TYPE: IGNORED.