TACL Reference Manual

Error Messages
HP NonStop TACL Reference Manual—429513-018
B-64
RELOAD Error Messages for H-Series, G-Series
and D-Series
Cause. A bad system-image file was indicated. The optionally supplied step # nn
indicates the execution step where the problem occurred:
Effect. The reload of the indicated CPU fails.
Recovery. Check that you used the correct alternate system-image file. Correct it or
try a different one, and reissue the command.
Cause. The attempted reload was aborted because of a bus or loading error, or the
default bus is down. There may have been a failure of another CPU during the reload.
The optionally supplied step # nn indicates the execution step where the problem
occurred:
Effect. The reload of the indicated CPU fails.
Recovery. Prime the CPU and retry the command. If this does not work, the CPU or
bus could be bad; try another bus.
CPU nn reload FAILED: bad file type [, step # nn].
01 to 09 Initialization and sending initial boots (microcode and bootstraps)
20 to 29 Common logic for sending packets over the bus (either initial boots or
CPU image)
30 to 39 Setting breakpoints
80 to 99 Starting processing in the reloaded CPU, including sending the
destination control table (DCT) starting processes, TMF initialization,
setting the clock, and so on.
CPU nn reload FAILED: bus or loading error [, step nn].
01 to 09 Initialization and sending initial boots (microcode and bootstraps)
20 to 29 Common logic for sending packets over the bus (either initial boots or
CPU image)
30 to 39 Setting breakpoints
80 to 99 Starting processing in the reloaded CPU, including sending the
destination control table (DCT) starting processes, TMF initialization,
setting the clock, and so on.