TACL Reference Manual

Error Messages
HP NonStop TACL Reference Manual—429513-018
B-65
RELOAD Error Messages for H-Series, G-Series
and D-Series
Cause. There was a file-system error, probably with the system-image file, on the
attempted reload. The optionally supplied step # nn indicates the execution step where
the problem occurred:
Effect. The reload of the indicated CPU fails.
Recovery. See “File-System Errors” in the Guardian Procedure Errors and Messages
Manual for corrective action for the error indicated by nnn. If this does not correct the
problem, reprime the CPU and run RELOAD in a different CPU.
Cause. There were not enough LCBs to handle the reload. The optionally supplied
step # nn indicates the execution step where the problem occurred:
Effect. The reload of the indicated CPU fails.
Recovery. Retry the command. If that does not work, use PEEK to determine which
CPUs have LCBs available and run RELOAD in a different CPU.
CPU nn reload FAILED: File system error # nnn [, step # nn].
01 to 09 Initialization and sending initial boots (microcode and bootstraps)
20 to 29 Common logic for sending packets over the bus (either initial boots or
CPU image)
30 to 39 Setting breakpoints
80 to 99 Starting processing in the reloaded CPU, including sending the
destination control table (DCT) starting processes, TMF initialization,
setting the clock, and so on.
CPU nn reload FAILED: LCB allocation failed [, step # nn].
01 to 09 Initialization and sending initial boots (microcode and bootstraps)
20 to 29 Common logic for sending packets over the bus (initial boots or CPU
image)
30 to 39 Setting breakpoints
80 to 99 Starting processing in the reloaded CPU, including sending the
destination control table (DCT) starting processes, TMF initialization,
setting the clock, and so on.