TAL Reference Manual

About This Manual
TAL Reference Manual—526371-001
xli
Additional Information
If you need to develop and maintain C-series TAL applications on a D-series system,
the following files must be restored from the C-series system:
The C-series compiler expects a C-series BINSERV and SYMSERV in the same
subvolume (although you can use the PARAM command to specify a BINSERV and
SYMSERV in a different subvolume). C-series tool files (such as BIND and
CROSSREF) can also be restored.
To compile a C-series compilation unit on a D-series system, you must use the fully
qualified name of the C-series compiler; for example:
$myvol.mysubvol.TAL / IN mysrc / myobj
Additional Information
Table iii describes manuals that provide information about NonStop systems.
C-Series File to
Restore Description
TAL TAL Compiler
TALERROR TAL Error Messages
TALLIB TAL Run-time Library
TALDECS TAL External Declarations
FIXERRS TACL macro for correcting TAL source files
BINSERV Binder server for compilers
SYMSERV Symbol-table server for compilers
Table iii. System Manuals
Manual Description
Introduction to HP
NonStop Systems
Provides an overview of the system hardware and software.
Introduction to D-
Series Systems
Provides an overview of D-series enhancements to the
operating system.
System Description
Manual
Describes the system hardware and the process-oriented
organization of the operating system.
TACL Reference
Manual
Describes the syntax for specifying TACL command
interpreter commands.
D-Series System
Migration Planning
Guide
Gives guidelines for migrating from a C-series system to a D-
series system.