Tandem Logon Manager for IBM Systems (ILOGMGR) Manual

Configuring for the ILOGMGR
Tandem Logon Manager for IBM Systems (ILOGMGR) Manual—127335 3-7
VTAM Appl Definition File Example
PUTYPE=2,
XID=YES,
MODETAB=MODETAB1,
DLOGMOD=CICSLU62
TN1 LU LOCADDR=0,RESSCB=10
For additional information on configuring VTAM lists, see the IBM manual, Network
Control Programming Resource Definition Reference.
Example ILOGMGR Configurations For Token-Ring
The following examples show you how to configure ILOGMGR for use with
Token-Ring.
VTAM List Entry Example
SWTAN1 VBUILD TYPE=SWNET, x
MAXGRP=2, x
MAXNO=2
*
TDMLGRPU PU ADDR=C1, x
IDBLK=0E3, x
IDNUM=000FC, x
ISTATUS=ACTIVE, x
MAXDATA=2042, x
MAXOUT=7, x
PASSLIM=7, x
PUTYPE=2, x
CPNAME=T16CPB, x
MODETAB=MODETAB1, x
DLOGMOD=CICSLU62
*
TDMLGR1 LU LOCADDR=0
The following naming correspondences are observed in the above example:
•
The CPNAME T16CPB is the same CPNAME used in the SCF configuration file
shown below in “SNAX/APN SCF Configuration File Example” (see the “ALTER
SUBSYS $SSCP” statement).
•
The LU name TDMLGR1 is also used in the SCF configuration file shown below in
“SNAX/APN SCF Configuration File Example” (see the “ADD LU” statement for
the local TLOGMGR LU).
•
The LU name TDMLGR1 is the same name used in the ILOGMGR control file
shown below in “Control File (ILOGCNTL) For ILOGMGR Example” (see the
“TLOGMGR=” statement).
VTAM Appl Definition File Example
ILM3 APPL ACBNAME=ILM3, x
AUTH=(ACQ,SPO,PASS)
TACL APPL ACBNAME=TACL, x
AUTH=(ACQ,SPO,PASS)