Tandem Logon Manager for IBM Systems (ILOGMGR) Manual

Multiple Instances of ILOGMGR and TLOGMGR
3-10 127335—Tandem Logon Manager for IBM Systems (ILOGMGR) Manual
Configuring for the ILOGMGR
In the above configuration, the control file and NCP are configured just as they are when
a single ILOGMGR is used since each ILOGMGR is communicating with a single
TLOGMGR over one SNAX/APN line.
The TLOGMGR, however, must be configured to account for the two ILOGMGRs. For
information about this configuration procedure, see the SNAX/APN Configuration and
Control Manual.
As a result of the Tandem SCF configuration, TLOGMGR1 can have sessions with both
ILOGMGR1 and ILOGMGR2. TLOGMGR1 can establish a session (SEND BIND) only
with the ILOGMGR that has been configured with SCF. However, the ILOGMGR that
has not been configured must initiate the session between the ILOGMGR and the
TLOGMGR.
Multiple ILOGMGRs in Session With Multiple TLOGMGRs Over
a SNAX/APN Line
Figure 3-2 shows two TLOGMGRs, each communicating with two ILOGMGRs.
Figure 3-1. A TLOGMGR Communicating With More Than One ILOGMGR
Figure 3-2. Multiple ILOGMGRs in Session With Multiple TLOGMGRs
TLOGMGR1
ILOGMGR1
line1
ILOGMGR2
007
ILOGMGR1
line1
ILOGMGR2
TLOGMGR1
TLOGMGR2
013
tcl1
tcl2