Tandem Logon Manager for IBM Systems (ILOGMGR) Manual

Multiple Instances of ILOGMGR and TLOGMGR
3-12 127335—Tandem Logon Manager for IBM Systems (ILOGMGR) Manual
Configuring for the ILOGMGR
In this configuration, the control file and the NCP must be configured for both
TLOGMGRs. Any applications that are accessed through either of the TLOGMGRs
must also be associated with the appropriate TLOGMGR. In this example, the control
file for the ILOGMGR is configured as follows:
ILOGMGR=ILOGMGR1
TLOGMGR=TLOGMGR1,
TDMAPPLS=tcl1
TLOGMGR=TLOGMGR2,
TDMAPPLS=tcl2
The NCP is configured as follows:
group1 GROUP…
line1 LINE…
pub PU XID=YES…
TLOGMGR1 LU…
group2 GROUP
line2 LINE
pub PU XID=YES
TLOGMGR2 LU…
On the Tandem side, SCF must be configured as follows:
ADD #TLOGMGR1, TYPE(14,21), SNANAME TLOGMGR1,
PROTOCOL LOGON, DLUNAME #ILOGMGR1
ADD #TLOGMGR2, TYPE(14,21), SNANAME TLOGMGR2,
PROTOCOL LOGON, DLUNAME #ILOGMGR1
As a result of this configuration, both TLOGMGR1 and TLOGMGR2 can initiate sessions
with ILOGMGR1.
Figure 3-3. An ILOGMGR in Session With Two TLOGMGRs on Separate Lines
line1
line2
ILOGMGR1
TLOGMGR1
TLOGMGR2
014
tcl1
tcl2