Tandem Logon Manager for IBM Systems (ILOGMGR) Manual

Tandem Logon Manager for IBM Systems (ILOGMGR) Manual—127335 4-1

Operating the ILOGMGR

Starting ILOGMGR

The ILOGMGR logon manager is started as a job under Multiple Virtual Storage

(MVS). You use the MVS START command with the appropriate procedure library

member name; in the following example, the name is ILOGMGR1. S is the short form of

the MVS START command.

S ILOGMGR1

In response, ILOGMGR1 sends the following reply:

T0100-ILOGMGR(ILOGMGR1) - T6919D21 (02/16/94) -

94.056 14:39:20

@nn T0200-ILOGMGR(ILOGMGR1)-ACCEPTING COMMANDS>>

The reply ID nn is used by the operating system to correlate replies with prompts, but

the reply ID is not used by the ILOGMGR.

Version Information

The following subsections describe how to access information about the version of

ILOGMGR you are using.

ILOGMGR Banner

When the ILOGMGR is started, message T0100 is displayed using a write-to-operator

(WTO) specifying either route code 2 or 11 as described in the following table:

Further information about the message is in Appendix A, “Error Messages and Sense

Codes.”

Version Proc

The version proc is compiled in the IBM object and can be displayed using the

BROWSE command under ISPF/PDF. To display the version proc, you select the

ILOGMGR object to BROWSE, then use the FIND subcommand.

For example, once the ILOGMGR object module is selected to BROWSE, issue

“F T6919.” When the version proc is found, it appears in the object module as shown in

the following example:

T6919D30^20MAR95^T6919^V003^AAB

Route Code Effect

2 Routes informational messages to the master console

11 Routes programmer information to the message class for the job and

writes the information on the system output device