Tandem Logon Manager for IBM Systems (ILOGMGR) Manual

Operating the ILOGMGR
Tandem Logon Manager for IBM Systems (ILOGMGR) Manual—127335 4-3
Controlling TLOGMGR Operation
In the above example, the command processor is instructed to attempt to establish a
session with the TLOGMGR named tn. This command causes a BIND to be sent to the
TLOGMGR.
REPLY nn,STOP TLOGMGR *
In the above example, the command processor is instructed to attempt terminating the
sessions with all active TLOGMGRs.
The ILOGMGR checks all commands for proper syntax. If the syntax is correct, the
ILOGMGR issues the following message:
T0018 - COMMAND ACCEPTED.
If the syntax for a command is incorrect, the ILOGMGR issues the following message:
T0019 - COMMAND REJECTED
If the error T0019 is displayed, check the syntax of the command you issued or use the
HELP command to obtain further information.
A HELP command allows you to obtain specific information about the ILOGMGR
command status. The output of this command is a multiline message consisting of one
or more of the following messages: T0020, T0021, T0022, T0023, and T0024 (see
Appendix A, “Error Messages and Sense Codes,” for details).