Tandem Logon Manager for IBM Systems (ILOGMGR) Manual

Error Messages and Sense Codes
Tandem Logon Manager for IBM Systems (ILOGMGR) Manual—127335 A-11
Error and Informational Messages
Cause. This information message is displayed whenever the ILOGMGR is started. It
cannot be suppressed.
Effect. ILOGMGR processing continues.
Recovery. Informational message only; no corrective action is needed.
T0200
job-name
is the job name associated with this execution of the ILOGMGR.
Cause. This information message is to notify the operator that an ILOGMGR is
accepting commands. This message is the result of Write To Operator with Reply
(WTOR) that the ILOGMGR keeps outstanding unless you have suppressed messages
by specifying the routing code as 0 (see “Routing Code Control Record” on page 3-3 for
information about the routing code control record). The message appears highlighted on
the console and is prefixed by an operating system-assigned number in the form of @nn.
When replying, the operator must always affix this number to the front of any
ILOGMGR COMMAND; for example:
MVS prompts with:
@92 T0200 - ILOGMGR ILOGMGR1 - ACCEPTING COMMANDS >>
The operator replies with:
Reply 92,STATUS TLOGMGR *
MVS also allows:
R 92,STATUS TLOGMGR *
92STATUS TLOGMGR *
Effect. ILOGMGR processing continues.
Recovery. Informational message only; no corrective action is needed.
T0300
Cause. This information message is to notify the operator that there was an error when
the CLTOUT data set was opened.
Effect. No messages will be logged, and ILOGMGR processing continues.
Recovery. Informational message only; no corrective action is needed.
T0200 - ILOGMGR job-name - ACCEPTING COMMANDS >>
T0300 - NO CLTOUT LOGGING - OPEN ERROR