Tandem Logon Manager for IBM Systems (ILOGMGR) Manual

SNA Sense Codes and User’s Terminal Messages
A-12 127335—Tandem Logon Manager for IBM Systems (ILOGMGR) Manual
Error Messages and Sense Codes
T0400
Cause. This message is to notify the operator that an uncorrectable I/O error occurred,
and the SYNAD routine was given control.
Effect. The CLTOUT data set is closed, and ILOGMGR processing continues.
Recovery. Informational message only; no corrective action is needed.
T0500
Cause. This message is to notify the operator that an uncorrectable I/O or OPEN error
occurred, and the DCB ABEND exit routine was given control.
Effect. The CLTOUT data set is closed, if it was open, and ILOGMGR processing
continues.
Recovery. Informational message only; no corrective action is needed.
SNA Sense Codes and User’s Terminal Messages
The ILOGMGR may terminate failed logon requests by returning the SNA sense codes
listed in Table A-1 to the user’s terminal.
If the TLOGMGR sends sense code
X'080A0109' to the user’s terminal, an additional
message also is displayed giving the reason for the Program Start Abort. This message
appears as follows:
LUNAME=lu-name, RUNAME=CINIT, SENSE=sense-data
The cause, effect, and recovery for the error associated with each sense code is described
under “T0025,” earlier in this section.
T0400 - CLTOUT LOGGING STOPPED - SYNAD EXIT
T0500 - CLTOUT LOGGING STOPPED - DCB EXIT
Table A-1. SNA Sense Codes
Displayed Code Code Meaning
X'080A0101' Permission denied, TLOGMGR not active
X'080A0102' Permission denied, BIND image length error
X'080A0103' Permission denied, user data length error
X'080A0107' Permission denied, a Program Start Request timed out
X'080A0108' Permission denied, the ILOGMGR received a negative response to a
Program Start Request
X'080A0109' Permission denied, the ILOGMGR received a Program Start Abort from
the TLOGMGR for this logon request