TCP/IP Configuration and Management Manual

SCF Reference
TCP/IP Configuration and Management Manual—427132-004
4-8
NonStop TCP/IP SCF Commands

In the STARTED summary state, the object is available for data transfer.

In the STOPPED summary state, the object is defined (that is, the object exists)
but it is not available for data transfer. The STOPPED summary state is not
applicable to the PROCESS object. If the PROCESS object is not STARTED, it is
undefined (that is, the process does not exist).

In the STARTING summary state, the object has been initialized and is attempting
to start.

In the FREE summary state, the server is not in use.

In the CONNECTING summary state, the server is waiting for an ATM API Connect
command to complete.

In the REGISTERING summary state, the server is waiting for an ATMARP reply to
an ATMARP request to register the SUBNET’s IP address with the ATMARP
server.

In the REGISTERED summary state, the SUBNET has successfully registered with
the ATMARP server.
NonStop TCP/IP SCF Commands
This subsection contains the following information:

A table describing the Subsystem Control Facility (SCF) commands supported by
the NonStop TCP/IP subsystem and the object types supported for each
command.

Detailed information on object specification syntax.

The following detailed information on each SCF command:

A description of the command function.

The command syntax.
ROUTE
X
X
SERVER
XXXX
SUBNET
XXX
Table 4-4. Valid Object Summary States
Object
STOPPED STARTED STARTING FREE CONNECTING REGISTERING REGISTERED