TCP/IP Configuration and Management Manual

SCF Reference
TCP/IP Configuration and Management Manual—427132-004
4-9
Supported Commands and Object Types

The object specification, which shows the supported object types and object
names.

Descriptions, by object type, of the attribute.

Considerations you should be aware of before using the command.

Command examples.
Supported Commands and Object Types
This section describes the SCF commands that are interpreted specifically for the
NonStop TCP/IP subsystem. The SCF Reference Manual for G-Series RVUs and the
SCF Reference Manual for H-Series RVUs provide general information about SCF
commands. You should be familiar with that information before reading the NonStop
TCP/IP subsystem-specific information provided here.
Table 4-5 lists the SCF commands and object types supported by the NonStop TCP/IP
subsystem; (the page number of the command description follows the command name,
and a page number under the object indicates both that the command is support for
that object and the page number for that specific command).
Note. The terms CPU and processor are used interchangeably in this section.
Note. Note that Table 4-5
does not describe commands supported by the X25AM and SLSA
subsystems. Such commands are covered in the SCF reference manuals for those
subsystems. The titles of those reference manuals are listed in the About This Manual
section.
Table 4-5. Commands and Object Types for NonStop TCP/IP SCF (page 1 of 2)
Object Types
SCF
Command
ADDRMAP ENTRY PROCESS ROUTE SERVER SUBNET null
ABORT Command on
page 4-12
4-12 4-13 4-13
ADD Command on
page 4-14
4-15 4-16 4-18 4-20 4-21
ALTER Command on
page 4-25
4-25 4-26 4-31
DELETE Command on
page 4-33
4-33 4-34 4-35 4-35 4-36
INFO Command on
page 4-37
4-37 4-38 4-41 4-45 4-47 4-48
LISTOPENS Command on
page 4-54
4-54