TCP/IP Configuration and Management Manual

SCF Reference
TCP/IP Configuration and Management Manual—427132-004
4-50
INFO SUBNET Command
SuName
is the name of the X.25 subdevice used by the SUBNET.
QIO
shows whether or not the SUBNET is currently using the QIO interface. QIO is
always on for Ethernet, ATM and SNAP type SUBNETs. (This attribute is not
applicable for X25AM SUBNETs.) ON indicates that the interface is currently using
QIO mode. OFF indicates that the interface is not currently using QIO mode.
R
shows whether or not the ICMP Router Discovery Protocol (IRDP) has been
enabled on the SUBNET. The displayed value can be Y (IRDP is ON), or N (IRDP
is OFF).
INFO SUBNET Display Format With Detail for ATM
The format of the INFO SUBNET with the detail option selected for an ATM SUBNET
is:
Name
is the name of the SUBNET. Note that in this example, #SN1 has an alias, listed
right below it. The IPADDRESS of the varies by the final digit only.
Devicename
is the name of the SLSA LIF that provides access to the Ethernet LAN, is the name
of the ATM adapter, or is the name of the X25AM line that provides access to the
X.25 network. Note that with loopback SUBNETs, the value \NOSYS.NOIOP,
meaning no system, no device name, is displayed. This value is displayed because
loopback SUBNETs are routed internally so that there is no device name to display.
TCPIP Info SUBNET \NEWYORK.$ZTC0.#EN3, DETAIL
Name Devicename *IPAddRESS TYPE *SUBNETMASK SuName QIO
*R
#EN3 \NEWYORK.$LAN03 51.0.0.1 ATM %HFFFFFF00 ON
N
Trace Status ........ OFF
Trace Filename ......
Interface MTU ....... 9180
Gateway.............. OFF
AtmAddr...
47:00:05:80:FF:E1:00:00:00:F2:1A:29:EB:00:00:00:00:01:B2:01
ATMARP Server Mode .. Server
ATM SELECTOR BYTE ... 1