TCP/IP Configuration and Management Manual

SCF Reference
TCP/IP Configuration and Management Manual—427132-004
4-51
INFO SUBNET Command
IPADDRESS
is the Internet address of this SUBNET and all the IP addresses of the aliases
associated with the SUBNET.
TYPE
is the SUBNET type. It can be LOOPBACK, ATM, ETHERNET, SNAP or X.25.
SUBNETMASK
is a 32-bit integer that specifies which portion of the network number and the IP
host address is to be masked to define a SUBNET.
SuName
is the name of the X.25 subdevice used by the SUBNET.
QIO
shows whether or not the SUBNET is currently using the QIO interface. QIO is
always on for Ethernet, ATM and SNAP type SUBNETs. (This attribute is not
applicable for X25AM SUBNETs.) ON indicates that the interface is currently using
QIO mode. OFF indicates that the interface is not currently using QIO mode.
R
shows whether or not the ICMP Router Discovery Protocol (IRDP) has been
enabled on the SUBNET. The displayed value can be Y (IRDP is ON), or N (IRDP
is OFF).
Trace Status
is ON if the SUBNET is being traced with SCF.
Trace Filename
is the name of the current trace file.
Interface MTU
is the maximum transmission unit that can be used on the SUBNET.
GATEWAY
directs the SUBNET to add a default filter on the LIF when set to ON. When an IP
packet comes in that does not match any filter on the LIF, the LIF routes the packet
to the SUBNET owning the default filter (that is, with GATEWAY ON). Only one
SUBNET on a LIF can own the default filter. The default is OFF.
AtmAddr
is the ATM address assigned to the ATM adapter being used by the SUBNET.