TCP/IP Configuration and Management Manual

SCF Reference
TCP/IP Configuration and Management Manual—427132-004
4-52
INFO SUBNET Command
ATMARP Server Mode
indicates whether the SUBNET has been configured to act as an ATMARP server
or client.
ATM SELECTOR BYTE
is the value of the selector byte the SUBNET uses.
INFO SUBNET Display With Detail for Ethernet
The format of the INFO SUBNET with the detail option selected for an Ethernet
SUBNET is:
Name
is the name of the SUBNET. Note that in this example, #SN1 has an alias, listed
right below it. The IPADDRESS of the varies by the final digit only.
Devicename
is the name of the SLSA LIF that provides access to the Ethernet LAN, is the name
of the ATM adapter or is the name of the X25AM line that provides access to the
X.25 network. Note that with loopback SUBNETs, the value \NOSYS.NOIOP,
meaning no system, no device name, is displayed. This value is displayed because
loopback SUBNETs are routed internally so that there is no device name to display.
IPADDRESS
is the Internet address of this SUBNET and all the IP addresses of the aliases
associated with the SUBNET.
TYPE
is the SUBNET type. It can be LOOPBACK, ATM, ETHERNET, SNAP or X.25.
TCPIP Detailed Info SUBNET \NEWYORK.$ZTC4.*
Name Devicename *IPAddRESS TYPE *SUBNETMASK SuName QIO *R
#EN1\NY.$LAN03 172.17.214.234 ETHERNET %HFFFFFF00 OFF N
Trace Status ........ OFF
Trace Filename ......
Interface MTU ....... 1500
Gateway.............. OFF
---Multicast Groups--- ---State---
224.0.0.1 STARTED
230.17.123.55 STARTING
239.1.2.3 STOPPED