TCP/IP Configuration and Management Manual

SCF Reference
TCP/IP Configuration and Management Manual—427132-004
4-93
STATUS PROCESS Command
PVC Name
shows the name of the PVC being used on the ATM adapter. Note that the name
does not include the name of the ATM adapter and needs to be added in this
manner.
Subnet
is the name of the SUBNET to which the PVC is associated.
Considerations

If the ENDPOINT parameter is supplied, you must issue the command specifying
all ENTRY objects, for example: STATUS ENTRY *, ENDPOINT 1234567.

The IPADDRESS attribute is used in the cases where an ARP or ATMARP table
entry is not named. If a name is supplied, the IPADDRESS attribute is ignored.

By specifying the ENDPOINT attribute, you can display all the ATMARP entries
that are also using the same ATM address entry.
STATUS PROCESS Command
The STATUS PROCESS command displays the dynamic state of the TCP/IP process
and any ports in use.
Command Syntax
OUT file-spec
causes any SCF output generated for this command to be directed to the specified
file.
PROCESS process-name
is a valid process name indicating the desired TCP/IP process. If you omit the
object name, SCF uses the assumed object name. For information about the
ASSUME command, see the SCF Reference Manual for G-Series RVUs or the
SCF Reference Manual for H-Series RVUs.
DETAIL
requests detailed status information for the process.
STATUS [ / OUT file spec / ] [ PROCESS process-name ]
[ , DETAIL ]