TCP/IP Configuration and Management Manual

SCF Reference
TCP/IP Configuration and Management Manual—427132-004
4-101
STATUS SERVER Command
Example
The following command requests status information on all servers running on the
system:
1>ASSUME PROCESS $ZTC0
2->STATUS SERVER
STATUS SERVER Display Format
The format of the display for the STATUS SERVER command is:
Name
is the name of the server.
ATM Endpoint Timer
shows the time left before some action may be taken. Under normal
circumstances, the time value is the amount of time left before the SUBNET re-
registers with the ATMARP server. What happens when the timer expires depends
on the state of the entry.
ATM State Flags
shows detailed information on the ATM address entry being used by the server.
Possible values are:
TCPIP Status SERVER \SAMCAT.$ZTC0.*
Name: #SRV2
ATM Endpoint Timer.. 487 (Sec) ATM State Flags..
(OUT,SRVR)
Endpoint............ 805582288D State............
REGISTERED
Subnet.............. #EN1
AtmAddr... (NSAP)
47:00:05:80:FF:E1:00:00:00:F2:1A:29:EB:00:00:00:00:01:B2:00
None (NONE)
Incoming connection
(IN)
indicates ATM connection was initiated from the
network.
Out going connection
(OUT)
indicates ATM connection was initiated by this process.
Resolving IP address
(RISP)
ATM address entry has issued an inverse ATM ARP
request to obtain the IP address of the other end of the
ATM connection.
ATMARP Server
Address (SRVR)
indicates an ATM connection to an ATMARP server.