TCP/IP Configuration and Management Manual

Configuration Quick Start
TCP/IP Configuration and Management Manual—427132-004
1-13
Assumptions

Process name (the example uses $ZTC1)

SUBNET Name (the example uses #EN1 and #LO*)

IP Address of the SUBNET (the example uses 172.16.192.203)

DEVICENAME for the Adapter (the example uses $AM2). See the Hint on
page 1-13 for information on how to obtain the adapter/device name.

Server Name (the example uses #SRV1 and #SRV2)

Server ATM Address (the example uses
H47000580FFE1000000F21A29EB0000000001A500 and
H47000580FFE1000000F21A29EB0000000001A300)

Subnet Mask Used on Local Subnet (the example uses 255.255.255.0 in dot
notation, which is %hffffff00 in hexadecimal format)

Route Name (the example uses #DEF (remember #RT is reserved))

Gateway Router Address address for connection to non-local systems (the
example uses 172.16.192.1)

Host Name (the example uses “TCPX”)

Entry Name (the example uses #A2)

ATM Address of the Entry (for the Gateway)
%H47000580FFE1000000F21A29EB0000000001A100)
Hint. Before you add your NonStop TCP/IP process pair, issue an SCF NAMES ADAPTER
ZZATM.* command. Select a running ATM adapter and issue an INFO ADAPTER $adapter-
name. The “Access List” field lists the available CPUs. Select two CPUs from the “CPUs with
Data Path” list. Use the CPUs you selected when specifying the primary and backup CPU
numbers for the TCP/IP process. When you add the subnet (see ADD SUBNET Command
on
page 4-21 for details) use your chosen adapter name for the DEVICENAME. (The adapter
names are highlighted in the command files shown in Example 1-6
, and Example 1-7.)
>SCF
->NAMES ADAPTER $ZZATM.*
This command returns a list of operational ATM adapters on
the system. Choose an adapter, and issue the INFO ADAPTER
$adapter-name command:
-> INFO ADAPTER $AM2
The following example shows the display that results from the INFO ADAPTER command:
ATM Info ADAPTER $AM2
Location (grp,mod,slot).... 1 ,1 ,54
Access List.................... ( 2,3 )
Amp Filename (in use)..... \SYSTEM.SYS02.AMP
Amp Filename (config)...... $SYSTEM.SYSNN.AMP
LIB Filename (in use)......... $SYSTEM.SYS02.ZATMSRL
LIB Filename (config)......... $SYSTEM.SYSNN.ZATMSRL